FAQ of TX531 Motherboard

I have some problems, installing the connector for the PS/2 mouse. The handbook, which the motherboard, is not 100% correct. On the motherboard there is a connector labeled with CN1 PS/2. This 4-pin connector is not described in the handbook. The connector from the PS/2 adapter has 5 pins. Do you have a newer handbook of the motherboard?

The PS/2 connect of TX531 motherboard as listing as below:

GREEN for PIN1

RED for PIN2

BLUE for PIN3

YELLOW for PIN4

　After I finished the Win95 setup program, the CD-ROM stopped working properly. It is unstable when reading data from the HDD.

　Please install the IDE control program. When the program is finished, please restart your system and check if there are three drivers on System Control Panel:

  1. Ali Bus Master PCI to IDE Controller
  2. Ali Primary Controller (Bus Master)
  3. Ali Secondary Controller (Bus Master)

　

FAQ for M/B